Enable EDT trace to file

1]Enable the tracing

In maintenance, type, edt trace tsp l2l3
Example of response:

HDLC CC on link 5 trace enable .

HDLC VERBOSE on link 5 trace enable .

*note
– same command is used to turn tracing off, so make sure the correct response is received.
-the isdn traces are CPU intensive and it is recommended that you save the tracing to a logfile, rather than leaving it outputting to the maintenance window.
2]Saving to a logfile

In maintenance, type, “edt enable logtofile ”

Example of response:

ENABLE VDSU LOGTOFILE 7 1 2 1

ENABLE TSP LOGTOFILE 7 1 2 1

The file will be called LDS_trace.rtf, which can be retrieved by ftp’ing to the 3300 and can be found in the /db directory.
Get this file and send, along with ccs trace , if possible.
3]Stop tracing to logfile

In maintenance, type, “edt disable logtofile ”

Example of response:

DISABLE VDSU LOGTOFILE 7 1 2 1

DISABLE TSP LOGTOFILE 7 1 2 1
4]Disable the tracing

In maintenance, type, “edt trace tsp l2l3 ”

Example of response:
HDLC CC on link 5 trace disable .

HDLC VERBOSE on link 5 trace disable .

Leave a Reply